What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
09.06.2025 02:07

Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
The other is “what does a “fuse” do?”
Why would a person always be so tired?
Because the load is inductive, the current lags the voltage.(by a bit).
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
A circuit breaker is similar, but is resettable.
Europe stock markets fall after Trump doubles steel tariffs - CNBC
Edit 2024–10.
In schematic diagrams this is the symbol for a fuse:
[image of Common-mode choke]
What baseball stories from the early days of the sport seem too bizarre to be true?
A fuse is a non-resetable over current circuit protector.
2024–10–16 [ OO OLAOYE OYEBODE ]
but this device (an Inductor) … impedes the rapid changes in the current.
Have you ever seen your wife being fucked?
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
What does a fuse do?
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
For this case there are devices called Metal oxide varistors (MOV).
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
what exactly is a ‘surge’ protector?
Did you become a cuckold for your wife?
There are two important concepts here.
What is lightning?
First Sentence:
There are three different concepts here that are getting confused.
(Dc diagram shown, AC is similar).
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
Senators get ready to roll out a new crypto bill - Politico
Barnstars:
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
At least they know the answer if they wanted it.
Upvotes:
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
Why am I sweating so much at night even though my room is really cold?
It seems Mohan does not understand the difference between a comment and an Answer.
[old diagram got deleted by accident]
So, the voltage could go up to 500 volts, and the fuse will not open up.
Japanese queue for hours as rice shortage deepens - Financial Times
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
2024–10–10[John johnson John Johnson ]
Long, dark 'streaks' spotted on Mars aren't what scientists thought - Live Science
Here is a simplified AC power diagram.
2024–10–14 [Omar Gharbi Omar Gharbi ]
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
What are some common examples of human hypocrisy?
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
The bolt then partially travels down the line to your home.
Why do some people dislike Gilmore girls?
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
This is where this question deviates from being a 'generic' question, and becomes more specific.
eight
But… the neutral is now “floating” because of the 1 ohm resistance.
This is 'the assistant's answer'
But it can get overloaded, and no longer works.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
The third is lightning and “how it gets conducted into a home.”
These are simplified answers to the original question, and does not change anything I wrote above.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
He then asserts :
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
At one ohm, the resistor has a maximum of 1 watt power.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
One
These devices are installed between the “hot” and “neutral” and protective ground.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
This is the picture of an electronic coil of wire wound around a core of magnetic material.
The MOV will conduct when the voltage exceeds 50% of line voltage.
I post the exact comment here.
He then describes Rainy Season and Lightning.
Now when you have a certain ac resistance, then a current flows in a loop.
This one hit behind the barn.
a photo is worth a thousand words.
One is “what exactly is in a ‘surge protector’ ? ”
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
It also is a device that limits the change in current flow.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
An AC voltage/ current source, and an ac inductive load.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
but I think this circuit , shows a few more pieces.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
so, what happens?
He then describes the function of a fuse.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
nine
This device then solves the entire problem.
This is where the MOV conducts again, and dissipated the energy.
the problem then depends on "how fast does the fuse operate?".
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.